VH Server Mac - Config Reverse Mode

Submitted by daver on #1

Hello,

Can you please assist me in customising the MAC Server so I can set it up in reverse mode to have it dial to my client.

At lease where about is the config file saved so I can configure it appropriately, it's not documented.

Looking forward to using the product.

Submitted by Michael on Wed, 2018/02/21 - 17:45

#2

You can setup the reverse client like this

1. Start the server on the mac
2. On the same server, start the virtualhere client
3. The OSX Hub will appear in the client, right click on the OSX Hub and select 'Reverse Clients"
4. Now click Add and enter the ip address of the remote client you want to connect to
5. On the remote client - right click USB Hubs->Specify Hubs -> Advanced -> Check "Enable Reverse Connections"
6. In about 15 seconds the server should reach out and connect to the client and the OSX Hub should automatically appear in the client.

Submitted by daver on Wed, 2018/02/21 - 19:42

#3

Thanks for the response.

I ended up noticing that there is a backup and restore config function.

I backed up the file, setup the server config manually and then restored it and it is dialling out to my client correctly.

Thanks!