Trying to setup to run on two windows computers only I am having trouble figuring out how to get the client to connect to the server. When i try to add a server I'm not sure what I am supposed to use as the hub name.
The server and client will automatically find each other if they are on the same network, otherwise you need to specify the IP address of the server in the virtualhere client by right clicking USB Hubs->Specify Hubs->Add then put in the IP address of the server and click OK.
it looks like the port 7575 is block on my client computer and I don't have anyway of unblocking it. Is there a way to specify a different port and if so which one do you recommend to use.
.
The server and client will automatically find each other if they are on the same network, otherwise you need to specify the IP address of the server in the virtualhere client by right clicking USB Hubs->Specify Hubs->Add then put in the IP address of the server and click OK.
it looks like the port 7575
it looks like the port 7575 is block on my client computer and I don't have anyway of unblocking it. Is there a way to specify a different port and if so which one do you recommend to use.
.
You can change the port of the server using the TCPPort= settings in the config.ini (note you need to have purchased the server to use this setting)
https://www.virtualhere.com/configuration_faq
You can choose any tcp basically. You could also give https://www.virtualhere.com/easyfind a try to see if it works that way