I have flashed VirtualHere on a new MT300N-V2 (firmware ver 3.102). After flashing the router boots up and I am able to access it via the Windows 10 64bit VirtualHere client. I am able to change the name and reboot the router but whenever I change the setting to make it part of an existing network I can no longer see it via the client software. The router boots up and gets an IP address but I can't find anyway to access it. I have used the 10 second recovery button to allow me to get back into the router via the VirtualHere client but once again if I make any network changes I can no longer access it. Any ideas on how I can fix this?
.
When the router joins your network it will broadcast its existence on UDP 5353.
The client is listening for this. If that is not being picked up by the client (e.g you have auto-find off or it is on a different network to the client ) you can manually enter the IP address by right clicking USB Hubs->Specify Hubs
Michael: Entering the IP
Michael: Entering the IP Address under Specify Hubs worked perfectly. Thank you!!!